|
Hydraulic
and Pneumatic Components and Systems Manufactured and Installed |
|
Manufacturers
of : Hydroline Hydraulic and Pneumatic Cylinders |
|
Distributors of: Waircom Pneumatic Products, Gear Pumps |
| Address: | ||
| 41 Trade Place Coburg 3058 Victoria Australia |
Phone: +61 3 9354-4266 Fax: +61 3 9354-5432 Email: airvalve@ssc.net.au |
|
| Contact: |
Graeme Theakstone
Joanne Theakstone |
|


BORE
SIZES: 1" to 20"
AIR CAPACITY: to 200 psi
HYDRAULIC CAPACITY: to 5000 psi
TEMPERATURE: to 400° F. Available
MOUNTINGS: 17 Available as Standard
ROD END STYLES: 6 Available as Standard








1. STUD
END... Eliminates thread relief-cause of fatigue failures.
2. PRESTRESSED
TIE RODS... made of high strength steel.
3. LEAKPROOF,
LOW FRICTION ROD SEALS... have flared lips for tight
seal at low pressure...heavy web for ample strength at high pressure.
4.
ACCURATELY MACHINED STEEL ENDS... for
perfectly aligned,"friction free" operation.
5.
LEAKPROOF TFE TUBE END SEALS... positive
sealing action because tube ends are piloted on the OD. Seals also resist
hydraulic fluids, corrosion, moisture, and continuous operating temperatures
up to 500° F.
6. AIR
BLEEDERS... available when specified. Improved tube
end construction permits automatic internal bleeding on non-cushioned ends.
7. MINIMUM
PRESSURE LOSS... large ports with NPT dry seal threads.
8. SIMPLIFIED
INSTALLATION... choice of six standard rod end styles.
9. WEAR-COMPENSATING
ROD WIPER... lathe-trimmed, double-lip design.
10.
REMOVABLE ROD CARTRIDGE... without
disturbing the cylinders tie rods which means easier maintenance.
11.
FULL CUSHION ADJUSTMENT... allowed
by improved needle.
12.
LONG ROD LIFE... is assured by
damage-resistant piston rods, case-hardened to 50-54 Rockwell "C"
and hard-chrome plated.
13.
CHOICE OF PISTON DESIGNS... lip type or ring type
to meet your requirements.
14.
FINELY HONED AND POLISHED TUBE ID... assures
maximum piston seal life.
15.
FAST RETURN STROKE... obtained
with large by-pass hole in ball-check valve.
AIR/HYDRAULIC
CYLINDER FEATURES...

URETHANE
ROD and PISTON SEALS
resist abrasive action at least four times longer than conventional
elastomers - help you fight wear caused by external misalignment. Also available
in highly durable fluoroelastomer (Dupont's Viton) for temperatures to 400°
F.

STUDDED
PISTON RODS
Tests show that studded piston rods resist fatigue failure
at least 40 times longer than conventional rods. Four rod styles available
as standard.

HEAVY-DUTY
ROD CARTRIDGES
The heart of the cylinder
The heavy duty rod cartridges have as much as 15% greater bearing surface
than most cylinders. This extra bearing length adds rod support and resists
wear from side loads caused by external misalignment.